Pre-Amp Condenser Microphone Circuit is straightforward, consisting of two levels. with wide dynamic regions, small noise, and can with an extended cable regarding 50 meters.
Note:
all capacitor (elco) using 25-voltto avoid the buzzing sound, use a good regulator supplay
This circuit can provide voltage 6-20volt
This circuit uses low noise transistors are kind types: BC 650 C but the transistor is hard to search out, so you'll replace it with 109 BC is not any less sensible. This condenser mic component in it's a really sensitive microphone, and to use this mic condenser needed voltage between 2-10 volts, for that we are able to resistors in series with 1K-10 K ohms, within the picture above the tide 1k ohms.
Pin BC109- Emitter
- Base
- ollector, connected to the case
BC109 limiting values
collector-base voltage 30 V
collector-emitter voltage 20 V
emitter-base voltage 5 V
collector current (DC) 100 mA
peak collector current 200 mA
peak base current 200 mA
total power dissipation Tamb £ 25 °C - 300 mW
storage temperature 65 +150 °C
junction temperature 175 °C
operating ambient temperature -65 +150 °C
DC current gain (hFE) IC = 10 mA; VCE = 5 V 100 -- 270
